Test equipments

With these equipments, it is possible to check on site the good function of our checking and rigging equipments in case of a doubt.

Syntester
See more
Thanks to this equipment, it is possible to optimize and facilitate the operating of the Syntham range of devices. Syntester has three main functions.

By simulating the signal emission, Syntester can:

• Check the good calibration.
• Check the good condition of the accelerometer cable.
• Make the understanding better during training in the classroom.

Cabletester
See more
Thanks to this equiment, you can check the low voltage electrical cables (below 50 volts AC). This shows that the cable is good or if is not the case, shows the existing anormaly with precision.

Accelerotester
See more
Thanks to this device, it is possible to check the good operating of the SteadyControl sensors (accelerometers, magnetic sensor and optical sensor) and of the Syntham (accelerometers).

RT Simulator
See more
Thanks to this device, it is possible to check the good operating of the Rotortuner sensors (accelerometers, magnetic sensor and optical sensor) and of the Syntham (accelerometers).

VibSim
See more
VibSim's purpose is to simulate on the workshop table or in a training room fix wings or rotating blades aircraft's vibrations.